Menu Close

Whirlpool Duet Dryer Won T Start Just Clicks

Whirlpool Duet Dryer Won T Start Just Clicks. A wrong selection like wrinkle reduction instead of timed or automatic cycle can disable the dryer’s start switch. It just clicks and does nothing.

My whirlpool duet dryer just stopped working. It did a load but now won from www.justanswer.com

The whirlpool dryer won’t start but has power if you see that your whirlpool dryer has power but won’t start, it might be an issue with your dryer door switch. Open the dryer door and remove screws inside the door frame. Try to press the start button and listen closely to your dryer.

It Has A Small Black Cap Over It.

The washing machine does not work because the cover switch is defective. A faulty door switch will not allow the dryer to operate. Is the door switch working properly?

Remove The Screws On The Rear Of The Control Panel To Release It.

If there is a humming sound, but the dryer does not start, then the switch is not bad. How old is your whirlpool dryer? Whirlpool duet dryer wont start just clicks.

Same Day Shipping Anywhere In The Us.

Bulkhead parts for whirlpool gew9250pw1. Shut dryer door, turned on, hit start button and it clicks once and goes to sensing light. If you hear a click or feel a short impulse, then your lid switch is working correctly.

It Also Stops It If The Door Is Opened During A Drying Cycle.

A deck switch is a defensive unit on top of the load washers beneath the deck. Open the dryer door and remove screws inside the door frame. We dried a load in it this morning, put the next load to dry in and the unit would not start.

When The Deck Is Open, The Lid Switch Will Not Allow The Engine To Operate.

Just as a precaution i am going to seal this with some tape and put a towel on top. You would need to take off the lower front access panel under your door, then take off the duct assembly#45, by removing the two #11 screws as shown in your parts diagram here: Unplug the dryer and remove the front panel.

Leave a Reply

Your email address will not be published.