How To Measure Trailer Axle Alignment. This procedure involves several steps: The face to face, mounting bracket centres (mbs) and the pcd.
Do the same on both sides of the trailer to complete your trailer axle alignment. Make sure the tires are fully inflated and the trailer is packed as if you are going to travel now. Then take the same measurement to the other wheel center.
Tie The Fishing Sinker To The End Of The Twine.
The face to face, mounting bracket centres (mbs) and the pcd. Next measure from the straightedge to the frame in back of the wheel and compare the two measurements. • set the designed kingpin height.
This Procedure Involves Several Steps:
Make sure that the sides of the hanger and plate are properly aligned. Measure your axle track length by determining the distance between the center of one tire to the center of the other how to measure trailer axle alignment. Measure and note the distance between the front wheel and rear wheel on either side of the trailer, if your trailer has a second axle.
Lower The Trailer Tongue Jack Stand.
They should be identical or within 1/8 of an inch, give or take 1/16 of an inch. Measurement # 2 = spring center. Do the same to the other side of the hanger.
Use Your Same Straightedge As Before:
Use a 1/4” drill bit to drill a pilot hole in the hanger. Both dimensions should be the same. Then take the same measurement to the other wheel center.
Another Way To Check The Alignment Of A Dual Axel Trailer Is To Measure.
Measuring properly to check trailer tire alignment requires parking your trailer on a flat surface. Both dimensions should be the same. Compare the distances between the right wheels and the left wheels.